New exit chute for Monolith Flat and 4 magnets.

Follow these instructions to install magnets into the exit chute since you need to orient them to match polarity of your grinder. Once you glue them in they cannot be pulled out so make sure you double check polarity and orientation.

To glue in magnets, use super glue. Clean magnet holes with Q-Tip and acetone. Then use toothpick to place glue inside of the holes. Note that you need to pay attention to magnet polarity otherwise if you glue it wrongly it will not attract but detract from its mating magnet. I recommend placing the magnet on each of its mates on grinder body so they stick correctly, then you put dot with pencil on the side that you see. That side will be glued into corresponding hole on exit chute so if you see the dot you know you did it wrong and have little time to get it out and reverse.

To put magnet in place you can use smaller hex key to be able to press magnet into the hole. Then using toothpick you can hold it while you remove hex key. Then you can press it in with toothpick if it needs more pressing. Use disposable gloves so you don't end up with glued fingers 🙂 Note that when you use this method you need to place magnet on its matching position on exit chute.